diff options
Diffstat (limited to 'source/n/network-scripts/scripts/rc.inet1.conf')
| -rw-r--r-- | source/n/network-scripts/scripts/rc.inet1.conf | 18 |
1 files changed, 13 insertions, 5 deletions
diff --git a/source/n/network-scripts/scripts/rc.inet1.conf b/source/n/network-scripts/scripts/rc.inet1.conf index 0daee701..e952498e 100644 --- a/source/n/network-scripts/scripts/rc.inet1.conf +++ b/source/n/network-scripts/scripts/rc.inet1.conf @@ -69,7 +69,7 @@ GATEWAY6="" # BONDNICS is a space delimited list of interfaces to add to this bond. The # BONDNICS interfaces will be brought up and configured while bringing up the # bond interface, so do not need to be previously defined in rc.inet1.conf. -# BONDMODE sets the bonding mode for this interface. If not specified when +# BONDMODE sets the bonding mode for this interface. If not specified when # BONDNICS has been used, the default is 'balance-rr'. # IFOPTS is a pipe (|) delimited list of bonding module specific settings to be # applied to the interface, and should always include the 'miimon' option when @@ -83,9 +83,7 @@ GATEWAY6="" #BONDNICS[0]="eth0 eth1" #BONDMODE[0]="balance-rr" #IFOPTS[0]="xmit_hash_policy layer2+3 | miimon 100" -#IPADDR[0]="192.168.0.1" -#NETMASK[0]="24" -#IPALIASES[0]="" +#IPADDRS[0]="192.168.0.1/24" #USE_DHCP[0]="" #DHCP_HOSTNAME[0]="" #IP6ADDRS[0]="" @@ -174,7 +172,7 @@ GATEWAY6="" # Some examples of additional network parameters that you can use. #IFNAME[4]="wlan0" # Use a different interface name instead of # the default 'eth4' -#IFOPTS[4]="" # A pipe (|) delimited list of interface type +#IFOPTS[4]="" # A pipe (|) delimited list of interface type # specific options to apply. These options # can be found in the ip-link(8) man page in # the approprite section for the interface @@ -200,6 +198,16 @@ GATEWAY6="" #SLAAC_TIMEOUT[4]="15" # The default timeout for auto configuration to # wait for the interface to come up is 15 sec. # Increase the timeout if required. +#SLAAC_PRIVIPGEN[4]="yes" # When assigning addresses via SLAAC, use the + # 'private' (RFC7217) address generation method. + # It is advisable to also set SLAAC_SECRET[x]. +#SLAAC_SECRET[4]="xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx" + # When SLAAC_PRIVIPGEN[x]="yes" is set, this is + # the secret to be used. This must be in the + # form of an IPv6 address. When left unset, a + # random secret is used (this is the default). +#SLAAC_TEMPADDR[4]="yes" # Use a temporary address with SLAAC to enhance + # security. #USE_RA[4]="yes" # Accept router advertisements even when SLAAC # is disabled on the interface. #WLAN_ESSID[4]="DARKSTAR" # An example of how you can override _any_ |